Frigidaire Front-Load (Affinity) Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 15 codes covered.
Shop Frigidaire Front-Load (Affinity) parts at RepairClinic or Amazon
- E11 — Fill time too long: the front-load washer did not reach the target water level within the allowed time (about 8 minutes).
- E13 — Water leak in the tub, or an air leak in the water level pressure sensor air hose (air bell).
- E14 — The dispenser drawer is not closed, so the washer will not start or continue correctly.
- E21 — Water is not pumping out fast enough: the washer drains too slowly and pauses with water left in the tub.
- E23 — The drain pump relay on the main control board has failed, or a wire is off the drain pump.
- E24 — The drain pump relay circuit on the control board has failed, or a wire is off the drain pump (same drain-pump circuit fault family as E23).
- E31 — The water level pressure sensor is not communicating with the electronic control board, so the washer cannot read the water level.
- E35 — The water level pressure sensor detects an overfill: there is too much water in the tub.
- E36 — The control board itself has a problem and the washer cannot run reliably.
- E41 — The control board thinks the door switch is open, so the washer will not lock or start.
- E43 — The control detects a problem with the door lock circuit.
- E52 — Bad signal from the drive motor tachometer: the control cannot read the motor speed correctly.
- E56 — High motor current: the drive motor is drawing too much current, usually because it is overloaded or failing.
- EF1 — The drain pump is clogged, so water cannot leave the tub properly.
- EF2 — Too much soap: the washer detects excess suds from too much detergent or the wrong detergent type.