Frigidaire Washer Front-Load (Affinity) E56 Error Code
What the E56 code means
High motor current: the drive motor is drawing too much current, usually because it is overloaded or failing.
Likely causes
- Washer overloaded
- Drum or motor binding
- Failing drive motor → Shop the drive motor at RepairClinic
- Motor control board fault → Shop the motor control board at RepairClinic
How to fix it — step by step
- Unplug the washer and remove part of the load
- Turn the drum by hand to check it moves freely
- Restart with a smaller load
- If E56 returns on a normal load, book service for the motor circuit
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the drive motor.
Shop the drive motor at RepairClinic or Amazon
Also tied to this fault: motor control board - Shop at RepairClinic or Amazon
Parts that commonly fix the E56 code
- drive motor - Shop at RepairClinic or Amazon
- motor control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Frigidaire manual is on Frigidaire's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.