Frigidaire Washer Front-Load (Affinity) E14 Error Code
What the E14 code means
The dispenser drawer is not closed, so the washer will not start or continue correctly.
Likely causes
- Dispenser drawer left open or not fully pushed in
- Drawer blocked by detergent buildup
- Faulty drawer reed switch → Shop the reed switch at RepairClinic
How to fix it — step by step
- Push the dispenser drawer fully closed
- Clean dried detergent from the drawer and housing
- Restart the cycle
- If the code stays with the drawer shut, the drawer switch needs service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the dispenser drawer magnet.
Shop the dispenser drawer magnet at RepairClinic or Amazon
Also tied to this fault: reed switch - Shop at RepairClinic or Amazon
Parts that commonly fix the E14 code
- dispenser drawer magnet - Shop at RepairClinic or Amazon
- reed switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Frigidaire manual is on Frigidaire's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.