Frigidaire Washer Front-Load (Affinity) E31 Error Code
What the E31 code means
The water level pressure sensor is not communicating with the electronic control board, so the washer cannot read the water level.
Likely causes
- Failed water level pressure sensor → Shop the water level pressure sensor at RepairClinic
- Loose or damaged sensor wiring
- Control board fault
How to fix it — step by step
- Unplug the washer for 5 minutes and try one cycle
- Check the washer is not overfilling or sitting with water in the tub
- If the code returns, do not keep restarting it
- Book service to test the pressure sensor and its wiring
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water level pressure sensor.
Shop the water level pressure sensor at RepairClinic or Amazon
Parts that commonly fix the E31 code
- water level pressure sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Frigidaire manual is on Frigidaire's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.