Frigidaire Washer Front-Load (Affinity) E35 Error Code
What the E35 code means
The water level pressure sensor detects an overfill: there is too much water in the tub.
Likely causes
- Water inlet valve stuck open
- Failed or clogged pressure sensor or its air hose
- Control board fault
How to fix it — step by step
- Turn off the water supply faucets right away
- If the washer keeps filling while unplugged, the inlet valve is stuck and needs replacing → Shop the water inlet valve at RepairClinic
- Unplug the washer and let it drain or bail out excess water
- Book service if the valve is not stuck, to test the pressure sensor
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water inlet valve.
Shop the water inlet valve at RepairClinic or Amazon
Also tied to this fault: water level pressure sensor - Shop at RepairClinic or Amazon
Parts that commonly fix the E35 code
- water inlet valve - Shop at RepairClinic or Amazon
- water level pressure sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Frigidaire manual is on Frigidaire's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.