Frigidaire Washer Front-Load (Affinity) E23 Error Code
What the E23 code means
The drain pump relay on the main control board has failed, or a wire is off the drain pump.
Likely causes
- Failed drain pump relay on the control board
- Wire disconnected from the drain pump
- Failed drain pump
How to fix it — step by step
- Unplug the washer for 5 minutes and restart one cycle
- Check the pump filter is clean so the pump is not straining → Shop the drain pump at RepairClinic
- Do not open the cabinet to chase wiring yourself
- Book service to test the pump, wiring and control board
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the main control board.
Shop the main control board at RepairClinic or Amazon
Also tied to this fault: drain pump - Shop at RepairClinic or Amazon
Parts that commonly fix the E23 code
- main control board - Shop at RepairClinic or Amazon
- drain pump - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Frigidaire manual is on Frigidaire's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.