Frigidaire Washer Front-Load (Affinity) E41 Error Code
What the E41 code means
The control board thinks the door switch is open, so the washer will not lock or start.
Likely causes
- Door not fully closed
- Clothing caught in the door seal
- Failed door lock or door switch
- Loose door lock wiring
How to fix it — step by step
- Open the door and close it firmly until it clicks
- Check no clothing is trapped in the door seal
- Wipe the seal and latch area clean
- If the code stays, the door lock assembly likely needs replacing → Shop the door lock assembly at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the door lock assembly.
Parts that commonly fix the E41 code
- door lock assembly - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Frigidaire manual is on Frigidaire's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.