Frigidaire Washer Front-Load (Affinity) EF2 Error Code
What the EF2 code means
Too much soap: the washer detects excess suds from too much detergent or the wrong detergent type.
Likely causes
- Too much detergent used
- Non-HE detergent in a high-efficiency washer
- Detergent buildup in the tub
How to fix it — step by step
- Run a rinse and spin cycle with no detergent
- Run the clean washer cycle if your model has one
- Switch to HE detergent and use less per load
- Restart normal loads once the suds are gone
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the EF2 code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Frigidaire manual is on Frigidaire's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.