Frigidaire Washer Front-Load (Affinity) E11 Error Code
What the E11 code means
Fill time too long: the front-load washer did not reach the target water level within the allowed time (about 8 minutes).
Likely causes
- Supply faucets not fully open
- Fill hoses kinked or hot and cold hoses reversed
- Clogged inlet valve screens
- Failed water inlet valve
How to fix it — step by step
- Open both supply faucets fully
- Check the fill hoses are not kinked and hot goes to hot, cold to cold
- Turn off the water and clean the inlet valve screens → Shop the water inlet valve at RepairClinic
- Restart the cycle; if E11 returns, the inlet valve likely needs replacing
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water inlet valve.
Parts that commonly fix the E11 code
- water inlet valve - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Frigidaire manual is on Frigidaire's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.