Dreame Dreame W10 Common Problems
Find your problem in the list below. Each page explains the most likely causes, step-by-step checks you can do yourself, when to call a pro, and the parts that commonly resolve it. 28 problems covered.
Shop Dreame Dreame W10 parts at Amazon
- A room-based map cannot be created in the app — The robot fails to build its first room-based map.
- Base display error: "Fresh Tank Not Installed" — The base display reports that the fresh (clean water) tank is not installed.
- Base display error: "Insufficient Water in Fresh Tank" / Water in the fresh tank is insufficient — The base display reports insufficient water in the fresh tank, or the warning persists after refilling.
- Base display error: "Waste Tank Malfunction" — The base display reports a waste (used water) tank malfunction.
- The charging speed is slow — Charging takes much longer than usual; a full charge from low battery takes about 6 hours.
- The cleaning performance is poor — The robot leaves dirt behind or cleans weakly.
- The mop pad falls off — The mop pad detaches during cleaning.
- The noise increases while the robot is operating — The robot becomes noticeably louder during cleaning.
- The robot cannot find the base or will not return to the base — The robot cannot locate or return to its base on its own.
- The robot does not respond to the base — Commands from the base have no effect on the robot.
- The robot fails to connect to Wi-Fi — The robot cannot join Wi-Fi during app setup.
- The robot gets into trouble while working and stops — The robot stops working mid-task and shuts down.
- The robot is malfunctioning — The robot behaves abnormally or stops working correctly.
- The robot is stuck and stops operating — The robot gets trapped and stops mid-clean.
- The robot is stuck in front of the base and cannot return to the base — The robot stops in front of the base and cannot dock.
- The robot leaks dust while cleaning — Dust escapes from the robot during cleaning.
- The robot makes a strange noise while operating — An unusual noise comes from the robot's wheels or underside while it runs.
- The robot misses the rooms to be cleaned — Rooms that should be cleaned are skipped. Note the W10's threshold limit in its manual is about 1.8 cm, lower than the Ultra models.
- The robot moves without following the set route — The robot deviates from its planned route.
- The robot often strays into no-go zones or areas with virtual walls — The robot enters areas that were marked off-limits in the app.
- The robot will not charge — The robot is on the base but does not charge.
- The robot will not clean automatically at the scheduled time — A scheduled cleaning does not start.
- The robot will not resume cleaning after charging — After charging mid-task, the robot does not continue cleaning.
- The robot will not turn off — The robot cannot be switched off with the button.
- The robot will not turn on — The robot does not power on.
- The side brush falls off — The side brush detaches during cleaning.
- The washboard is not installed (base display error: "Washboard Not Installed") — The base display reports that the washboard is not installed.
- The water level in the washboard is abnormal — The W10 base washboard holds an abnormal water level; the same wording appears in the base's on-screen error table.