Dreame Robot vacuum Dreame W10 The robot misses the rooms to be cleaned
What this problem usually means
Rooms that should be cleaned are skipped. Note the W10's threshold limit in its manual is about 1.8 cm, lower than the Ultra models.
Likely causes
- Doors of the rooms are closed
- A threshold higher than 1.8 cm at the door
- The place in front of the room is wet and slippery, causing the robot to slip
- A small door mat or carpet at the door is avoided while the robot is mopping (carpet recognition)
How to fix it — step by step
- Make sure the doors of the rooms to be cleaned are open
- Check whether there is a threshold higher than 1.8 cm at the door of the room
- Dry the floor in front of the room before using the robot
- If a door mat or carpet is being avoided while mopping, turn off the carpet recognition function on the Setting page of the app
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Dreame Robot vacuum Dreame W10 problems
- The robot moves without following the set route
- The robot often strays into no-go zones or areas with virtual walls
- The robot will not charge
- The robot will not clean automatically at the scheduled time
- The robot will not resume cleaning after charging
- The robot will not turn off
- The robot will not turn on
- The side brush falls off
- The washboard is not installed (base display error: "Washboard Not Installed")
- The water level in the washboard is abnormal
- A room-based map cannot be created in the app
- Base display error: "Fresh Tank Not Installed"