Dreame Robot vacuum Dreame W10 The robot will not resume cleaning after charging
What this problem usually means
After charging mid-task, the robot does not continue cleaning.
Likely causes
- Do Not Disturb (DND) mode is set
- The robot was manually recharged or placed onto the base
How to fix it — step by step
- Make sure the robot is not set to Do Not Disturb (DND) mode
- Note that the robot does not resume cleaning when it is manually recharged or placed onto the base; start a new task instead
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Dreame Robot vacuum Dreame W10 problems
- The robot will not turn off
- The robot will not turn on
- The side brush falls off
- The washboard is not installed (base display error: "Washboard Not Installed")
- The water level in the washboard is abnormal
- A room-based map cannot be created in the app
- Base display error: "Fresh Tank Not Installed"
- Base display error: "Insufficient Water in Fresh Tank" / Water in the fresh tank is insufficient
- Base display error: "Waste Tank Malfunction"
- The charging speed is slow
- The cleaning performance is poor
- The mop pad falls off