Dreame Robot vacuum Dreame W10 The water level in the washboard is abnormal

What this problem usually means

The W10 base washboard holds an abnormal water level; the same wording appears in the base's on-screen error table.

Likely causes

  1. The sewage drain is blocked
  2. The metal elastic pieces of the overflow sensor within the washboard are dirty
  3. The waste tank is not installed in place
  4. The sealing ring of the waste tank is loose or not installed properly

How to fix it — step by step

  1. Remove the washboard, check whether the sewage drain is blocked, and clean it
  2. Wipe the metal elastic pieces of the overflow sensor within the washboard with a dry cloth
  3. Gently press down on the waste tank to ensure it is installed in place
  4. Check whether the sealing ring of the waste tank is loose or not installed properly, and reset it manually if so
  5. If the problem persists, contact after-sales service

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Dreame Robot vacuum Dreame W10 problems

See all Dreame Dreame W10 codes & guides →