Dreame Robot vacuum Dreame W10 The robot is stuck and stops operating
What this problem usually means
The robot gets trapped and stops mid-clean.
Likely causes
- Obstacles such as power cords, curtains, or carpet tassels around the robot
- The robot is stuck by furniture
How to fix it — step by step
- Check the area and remove obstacles such as power cords, curtains, or carpet tassels so the robot can continue
- Elevate the furniture, place a physical barrier to block off the problem areas, or set no-go zones in the app
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Dreame Robot vacuum Dreame W10 problems
- The robot is stuck in front of the base and cannot return to the base
- The robot leaks dust while cleaning
- The robot makes a strange noise while operating
- The robot misses the rooms to be cleaned
- The robot moves without following the set route
- The robot often strays into no-go zones or areas with virtual walls
- The robot will not charge
- The robot will not clean automatically at the scheduled time
- The robot will not resume cleaning after charging
- The robot will not turn off
- The robot will not turn on
- The side brush falls off