Dreame Robot vacuum Dreame W10 Base display error: "Insufficient Water in Fresh Tank" / Water in the fresh tank is insufficient
What this problem usually means
The base display reports insufficient water in the fresh tank, or the warning persists after refilling.
Likely causes
- Fresh tank needs replenishing
- Fresh tank is not seated correctly
- Dirt at the bottom of the fresh tank or in its filter media
- Foreign objects on the metal filter at the water inlet of the base
How to fix it — step by step
- Add a sufficient amount of water to the fresh tank / replenish clean water in time
- Unplug the power cord of the base, take out the fresh tank and put it back, then power on the base and try again
- Pour out the remaining water in the fresh tank, rinse the bottom of the fresh tank and the filter media, then add water and try again
- Check the metal filter at the water inlet of the base and remove any foreign objects
- If the problem persists, contact after-sales service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Dreame Robot vacuum Dreame W10 problems
- Base display error: "Waste Tank Malfunction"
- The charging speed is slow
- The cleaning performance is poor
- The mop pad falls off
- The noise increases while the robot is operating
- The robot cannot find the base or will not return to the base
- The robot does not respond to the base
- The robot fails to connect to Wi-Fi
- The robot gets into trouble while working and stops
- The robot is malfunctioning
- The robot is stuck and stops operating
- The robot is stuck in front of the base and cannot return to the base