Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar E240 Error Code

What the E240 code means

On newer Lennox furnaces (EL296, SL280, SLP98, ML296 and similar) showing three-digit codes from the Lennox Residential Communicating Systems Alert Code Guide, E240 means low flame current in run mode — the flame sensor signal is weak while the burners run.

Likely causes

  1. Dirty or oxidized flame sensor
  2. Poor burner ground
  3. Exhaust recirculating into the intake at the termination

How to fix it — step by step

  1. Replace the air filter and open all registers
  2. Check that the outdoor exhaust is not blowing back into the intake termination
  3. Note if the furnace short-cycles
  4. Call a technician to clean or replace the flame sensor and measure flame current → Shop the flame sensor at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the E240 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar error codes

See all Lennox Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar codes & guides →