Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar E290 Error Code
What the E290 code means
On newer Lennox furnaces (EL296, SL280, SLP98, ML296 and similar) showing three-digit codes from the Lennox Residential Communicating Systems Alert Code Guide, E290 means an ignition circuit fault in Watchguard — igniter resistance is out of range or the igniter triggering circuit has failed (seven-segment wording: failed ignitor or triggering circuit).
Likely causes
- Failed hot surface igniter (resistance out of range) → Shop the hot surface igniter at RepairClinic
- Failed igniter circuit on the control board
- Loose igniter wiring
How to fix it — step by step
- Confirm the thermostat is calling for heat
- Reset power once and listen for the ignition sequence
- Stop resetting if E290 returns
- Call a technician to test and replace the igniter or control board → Shop the control board at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the hot surface igniter.
Shop the hot surface igniter at RepairClinic or Amazon
Also tied to this fault: control board - Shop at RepairClinic or Amazon
Parts that commonly fix the E290 code
- hot surface igniter - Shop at RepairClinic or Amazon
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.