Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar E200 Error Code
What the E200 code means
On newer Lennox furnaces (EL296, SL280, SLP98, ML296 and similar) showing three-digit codes from the Lennox Residential Communicating Systems Alert Code Guide, E200 means the rollout limit switch is open — flame has left the burner compartment. This is a hard safety fault (on seven-segment ML-series controls it shows as a hard lockout, rollout circuit open).
Likely causes
- Blocked or cracked heat exchanger
- Blocked venting causing rollout
- Failed rollout switch
How to fix it — step by step
- Turn the furnace off and leave it off
- Do not reset the rollout switch yourself → Shop the rollout switch at RepairClinic
- Call a technician to inspect the heat exchanger and venting before the furnace runs again
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the rollout switch.
Parts that commonly fix the E200 code
- rollout switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.