Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar E250 Error Code
What the E250 code means
On newer Lennox furnaces (EL296, SL280, SLP98, ML296 and similar) showing three-digit codes from the Lennox Residential Communicating Systems Alert Code Guide, E250 means the primary limit switch is open — the furnace overheated, almost always an airflow problem first. If it stays open 3 minutes the furnace enters a 60-minute Watchguard.
Likely causes
- Dirty air filter
- Closed registers or blocked returns
- Failing blower motor → Shop the blower motor at RepairClinic
- Failed limit switch → Shop the limit switch at RepairClinic
How to fix it — step by step
- Turn the thermostat down and let the furnace cool
- Replace the air filter
- Open all supply registers and clear blocked returns
- Call for heat once after cooling; if E250 returns, call a technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the limit switch.
Shop the limit switch at RepairClinic or Amazon
Also tied to this fault: blower motor - Shop at RepairClinic or Amazon
Parts that commonly fix the E250 code
- limit switch - Shop at RepairClinic or Amazon
- blower motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.