Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar E207 Error Code
What the E207 code means
On newer Lennox furnaces (EL296, SL280, SLP98, ML296 and similar) showing three-digit codes from the Lennox Residential Communicating Systems Alert Code Guide, E207 means the hot surface igniter is sensed open — the igniter circuit is open, usually because the igniter has cracked or failed.
Likely causes
- Cracked or burned-out hot surface igniter → Shop the hot surface igniter at RepairClinic
- Loose igniter connector
- Open igniter wiring
How to fix it — step by step
- Confirm the thermostat is calling for heat
- Reset power once and listen for the ignition sequence
- If the igniter never glows and E207 returns, stop resetting
- Call a technician to test igniter resistance (Lennox specifies roughly 39-70 ohms on SureLight igniters) and replace it
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the hot surface igniter.
Parts that commonly fix the E207 code
- hot surface igniter - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.