Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar E241 Error Code
What the E241 code means
On newer Lennox furnaces (EL296, SL280, SLP98, ML296 and similar) showing three-digit codes from the Lennox Residential Communicating Systems Alert Code Guide, E241 means flame out of sequence and still present — the control senses flame when the gas valve should be closed. Lennox's documented first step is shutting off the gas.
Likely causes
- Gas valve leaking or stuck open
- Failed control board → Shop the control board at RepairClinic
- Shorted flame-sense wiring
How to fix it — step by step
- Shut off the gas supply to the furnace and turn furnace power off
- Do not try to restart the furnace
- If you smell gas, leave the house and call the gas utility from outside
- Call a technician to test the gas valve before the furnace is used again → Shop the gas valve at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the gas valve.
Shop the gas valve at RepairClinic or Amazon
Also tied to this fault: control board - Shop at RepairClinic or Amazon
Parts that commonly fix the E241 code
- gas valve - Shop at RepairClinic or Amazon
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.