Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar E224 Error Code
What the E224 code means
On newer Lennox furnaces (EL296, SL280, SLP98, ML296 and similar) showing three-digit codes from the Lennox Residential Communicating Systems Alert Code Guide, E224 means the low pressure switch is stuck closed — it reads closed when it should be open.
Likely causes
- Pressure switch stuck closed
- Moisture in the pressure switch
- Very quick re-call for heat confusing the check
How to fix it — step by step
- Check the condensate drain and vent terminations for blockages
- Reset power once and note if the code appears before the inducer runs
- Call a technician to test or replace the pressure switch if it returns → Shop the pressure switch at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the pressure switch.
Parts that commonly fix the E224 code
- pressure switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.