Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar E270 Error Code

What the E270 code means

On newer Lennox furnaces (EL296, SL280, SLP98, ML296 and similar) showing three-digit codes from the Lennox Residential Communicating Systems Alert Code Guide, E270 is a Watchguard soft lockout — flame failed to ignite through all retries (five failed tries), so the furnace shut down and will retry after the Watchguard period.

Likely causes

  1. Failed hot surface igniter → Shop the hot surface igniter at RepairClinic
  2. Dirty flame sensor → Shop the flame sensor at RepairClinic
  3. Gas supply off or interrupted
  4. Dirty filter or blocked drain interrupting the sequence

How to fix it — step by step

  1. Confirm the gas shutoff is open and other gas appliances work
  2. Replace a dirty air filter and check the condensate drain
  3. Wait out the Watchguard or reset power once
  4. If it locks out again, call a technician to test the igniter, sensor and gas valve → Shop the gas valve at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the E270 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar error codes

See all Lennox Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar codes & guides →