Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar E271 Error Code
What the E271 code means
On newer Lennox furnaces (EL296, SL280, SLP98, ML296 and similar) showing three-digit codes from the Lennox Residential Communicating Systems Alert Code Guide, E271 is a Watchguard soft lockout — the low pressure switch opened repeatedly (five pressure-switch trips in one call for heat).
Likely causes
- Blocked vent or intake
- Frozen or clogged condensate drain
- Failing inducer or pressure switch → Shop the pressure switch at RepairClinic
How to fix it — step by step
- Clear the outdoor vent and intake terminations
- Check and clear the condensate drain if you can see a clog
- Wait out the Watchguard or reset power once
- Call a technician if it repeats, to test draft, the inducer and the switch
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the pressure switch.
Shop the pressure switch at RepairClinic or Amazon
Also tied to this fault: inducer motor - Shop at RepairClinic or Amazon
Parts that commonly fix the E271 code
- pressure switch - Shop at RepairClinic or Amazon
- inducer motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.