Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar E229 Error Code

What the E229 code means

On newer Lennox furnaces (EL296, SL280, SLP98, ML296 and similar) showing three-digit codes from the Lennox Residential Communicating Systems Alert Code Guide, E229 means ignition occurred on high fire — an informational alert, not a failure: the low-fire pressure switch did not close in time, so the furnace lit on high fire instead. Lennox classes this as Information only and no action is required.

Likely causes

  1. Low-fire pressure switch slow to close → Shop the pressure switch at RepairClinic
  2. Marginal vent or drain restriction on low fire

How to fix it — step by step

  1. No action is required if the furnace is heating normally
  2. Keep an eye on whether it appears constantly, which can hint at a developing vent or drain restriction
  3. Mention it at the next service visit if it shows up on every cycle

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the E229 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar error codes

See all Lennox Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar codes & guides →