Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar E228 Error Code
What the E228 code means
On newer Lennox furnaces (EL296, SL280, SLP98, ML296 and similar) showing three-digit codes from the Lennox Residential Communicating Systems Alert Code Guide, E228 means an inducer calibration issue — the variable-speed inducer could not calibrate, usually because of a vent, drain or pressure hose problem.
Likely causes
- Blocked or restricted vent
- Clogged condensate drain
- Kinked or cracked inducer pressure hose
- Failing inducer motor → Shop the inducer motor at RepairClinic
How to fix it — step by step
- Clear the outdoor vent and intake terminations
- Check the condensate drain for clogs
- Reset power once to allow a recalibration attempt
- Call a technician if E228 returns, to inspect the hoses and inducer
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the inducer motor.
Shop the inducer motor at RepairClinic or Amazon
Also tied to this fault: pressure switch - Shop at RepairClinic or Amazon
Parts that commonly fix the E228 code
- inducer motor - Shop at RepairClinic or Amazon
- pressure switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.