Lennox Furnace Residential Communicating Systems alert codes — EL296/SL280/SLP98/ML296 and similar E227 Error Code
What the E227 code means
On newer Lennox furnaces (EL296, SL280, SLP98, ML296 and similar) showing three-digit codes from the Lennox Residential Communicating Systems Alert Code Guide, E227 means the low pressure switch opened in run mode — draft was proved, then lost while the furnace was running (seven-segment wording: pressure switch opened during ignition or run).
Likely causes
- Vent or intake blocked during run
- Condensate backing up during run
- Failing inducer motor → Shop the inducer motor at RepairClinic
- Intermittent pressure switch → Shop the pressure switch at RepairClinic
How to fix it — step by step
- Clear the outdoor terminations
- Check the condensate drain hose for clogs, kinks or freezing
- Reset power once and watch a full cycle
- Call a technician if it recurs, to test draft and the inducer
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the pressure switch.
Shop the pressure switch at RepairClinic or Amazon
Also tied to this fault: inducer motor - Shop at RepairClinic or Amazon
Parts that commonly fix the E227 code
- pressure switch - Shop at RepairClinic or Amazon
- inducer motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.