Lennox Air Conditioner 402 Error Code
What the 402 code means
System pressure trip (critical alert), reported by the outdoor unit and shown on the iComfort Wi-Fi / S-series communicating thermostat on Lennox communicating air conditioners (e.g. SL18XC). Either the discharge or suction pressure level is out of limits, or the compressor is overloaded; the error clears after 4 consecutive normal compressor run cycles.
Likely causes
- Discharge pressure too high (dirty outdoor coil, failed outdoor fan, overcharge)
- Suction pressure too low (low charge, restriction, low airflow)
- Compressor overload
How to fix it — step by step
- Turn the system off and clean the outdoor coil; confirm the outdoor fan runs
- Replace a dirty indoor filter
- Have a technician measure discharge and suction pressures to find which limit tripped
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the High pressure switch.
Shop the High pressure switch at RepairClinic or Amazon
Also tied to this fault: Low pressure switch - Shop at RepairClinic or Amazon; Outdoor fan motor - Shop at RepairClinic or Amazon
Parts that commonly fix the 402 code
- High pressure switch - Shop at RepairClinic or Amazon
- Low pressure switch - Shop at RepairClinic or Amazon
- Outdoor fan motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.