Lennox Air Conditioner 408 Error Code
What the 408 code means
Compressor running continuously / welded contactor (critical alert), reported by the outdoor unit and shown on the iComfort Wi-Fi communicating thermostat on Lennox communicating air conditioners. The compressor runs continuously; the error clears after 1 normal compressor run cycle or after a power reset.
Likely causes
- Compressor contactor welded closed → Shop the compressor contactor at RepairClinic
- Outdoor control output stuck on
- Wiring short keeping the contactor energized
How to fix it — step by step
- Turn off power to the outdoor unit at the disconnect — the compressor may run with no thermostat call
- Have a technician replace the welded contactor and check the control output
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the Compressor contactor.
Parts that commonly fix the 408 code
- Compressor contactor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.