Lennox Air Conditioner 403 Error Code
What the 403 code means
Compressor short cycling (moderate alert), reported by the outdoor unit and shown on the iComfort Wi-Fi / S-series communicating thermostat on Lennox communicating air conditioners (e.g. SL18XC). The compressor ran for less than 3 minutes to satisfy a thermostat demand; the error clears after 4 consecutive normal run cycles or a power reset.
Likely causes
- Intermittent thermostat demand or thermostat fault
- Pressure switch opening shortly after start (charge or airflow problem)
- Oversized unit short cycling on a small load
How to fix it — step by step
- Check thermostat settings and that the filter is clean
- Note how long the compressor runs before stopping
- Have a technician check pressures and pressure switches if short cycling continues → Shop the low pressure switch at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the Low pressure switch.
Shop the Low pressure switch at RepairClinic or Amazon
Also tied to this fault: High pressure switch - Shop at RepairClinic or Amazon
Parts that commonly fix the 403 code
- Low pressure switch - Shop at RepairClinic or Amazon
- High pressure switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.