Lennox Air Conditioner 401 Error Code
What the 401 code means
Long run time / possible low pressure (moderate alert), reported by the outdoor unit and shown on the iComfort Wi-Fi / S-series communicating thermostat on Lennox communicating air conditioners (e.g. SL18XC). Either the compressor ran more than 18 hours continuously on a single cooling demand, or refrigerant pressure in the system is low; the system is not locked out.
Likely causes
- Low refrigerant charge / refrigerant leak
- Low pressure switch trips during the long run → Shop the low pressure switch at RepairClinic
- Undersized unit or extreme heat load
- Restricted indoor airflow making the unit run continuously
How to fix it — step by step
- Replace a dirty indoor filter and make sure all vents are open
- Check that the outdoor coil is clean
- Have a technician check refrigerant charge and look for a leak if run times stay excessive
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the Low pressure switch.
Parts that commonly fix the 401 code
- Low pressure switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.