York Air Conditioner LED1 1 flash, LED2 off

What it should look like on your machine

then it repeats

1 flash - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

High-pressure switch fault (not in lockout yet) on the YorkGuard VI demand defrost / outdoor unit control in a York outdoor unit (heat pump models E*FH/E*EB/E*CS and communicating AC applications; Johnson Controls document 276251-UAI-A-0107, Table 5 Operational Fault Codes). The code is read on the outdoor control board: LED1 (red) flashes once, LED2 (green) is off, and the X/L thermostat output is off.

Likely causes

  1. High-pressure switch opened once — high head pressure
  2. Dirty outdoor coil or outdoor fan problem raising discharge pressure

How to fix it — step by step

  1. Turn the system off and clean the outdoor coil; confirm the outdoor fan runs
  2. If the fault escalates to lockout, have a technician check refrigerant pressures and the high-pressure switch → Shop the high-pressure switch at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related York Air Conditioner problems

See all York Air Conditioner codes & guides →