York Air Conditioner LED1 on steady, LED2 1 flash
What it should look like on your machine
then it repeats
1 flash - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Outdoor ambient sensor failure (short) on the YorkGuard VI demand defrost / outdoor unit control in a York outdoor unit (document 276251-UAI-A-0107, Table 6 Sensor or Switch Fault Codes). Sensor faults are displayed with LED1 (red) on constantly while LED2 (green) flashes the code — here 1 flash; the X/L output shows a soft-lockout signal.
Likely causes
- Shorted outdoor ambient temperature sensor → Shop the outdoor ambient temperature sensor at RepairClinic
- Sensor wiring shorted
How to fix it — step by step
- Turn off power to the outdoor unit
- Have a technician test the ambient sensor and wiring for a short and replace the sensor if failed
- Clear the stored fault code memory after the repair, as the manual directs
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Outdoor ambient temperature sensor.
Shop the Outdoor ambient temperature sensor at RepairClinic or Amazon
Parts that commonly fix it
- Outdoor ambient temperature sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.