York Air Conditioner LED1 on steady, LED2 2 flashes

What it should look like on your machine

then it repeats

2 flashes - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

Outdoor ambient sensor failure (open) on the YorkGuard VI demand defrost / outdoor unit control in a York outdoor unit (document 276251-UAI-A-0107, Table 6). LED1 (red) is on constantly and LED2 (green) flashes twice; the X/L output shows a soft-lockout signal. Per the manual, a shorted or open outdoor ambient sensor is also a wiring/setting lockout condition that stops compressor operation.

Likely causes

  1. Open outdoor ambient temperature sensor → Shop the outdoor ambient temperature sensor at RepairClinic
  2. Broken sensor wire or loose sensor connection

How to fix it — step by step

  1. Turn off power to the outdoor unit
  2. Check the ambient sensor connections at the control (AMB/AMBG terminals)
  3. Have a technician test and replace the sensor if open, then clear the fault memory

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related York Air Conditioner problems

See all York Air Conditioner codes & guides →