York Air Conditioner LED1 4 flashes, LED2 off
What it should look like on your machine
then it repeats
4 flashes - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Low-pressure switch lockout on the YorkGuard VI demand defrost / outdoor unit control in a York outdoor unit (document 276251-UAI-A-0107, Table 5). LED1 (red) flashes 4 times, LED2 (green) is off; the X/L output signals a soft (2-flash) or hard (3-flash) lockout at the thermostat. Per the manual, one low-pressure switch opening of more than five seconds (outside the exempt conditions) can cause a soft lockout.
Likely causes
- Low refrigerant charge / refrigerant leak
- Low-pressure switch open for more than five seconds
- Low airflow or a restriction dropping suction pressure
How to fix it — step by step
- Replace a dirty indoor filter and confirm the indoor blower runs
- Have a technician check refrigerant pressures and test the low-pressure switch before resetting the lockout → Shop the low-pressure switch at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the Low-pressure switch.
Parts that commonly fix it
- Low-pressure switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.