Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 E6.3 Error Code

What the E6.3 code means

On Trane S-series furnaces with a seven-segment display (S9X1, S9X2, S9B1 and S8X1, S8X2), code E6.3 means an igniter fault — the igniter relay has failed or the igniter is open.

Likely causes

  1. Burned-out or cracked hot surface igniter → Shop the hot surface igniter at RepairClinic
  2. Failed igniter relay on the control board → Shop the control board at RepairClinic
  3. Loose igniter connector

How to fix it — step by step

  1. Confirm the thermostat is calling for heat
  2. Reset power once and listen for the start sequence (inducer, then ignition attempt)
  3. If there is no ignition and the code returns, stop resetting
  4. Call a technician to test igniter resistance and replace the igniter or board

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the E6.3 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 error codes

See all Trane S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 codes & guides →