Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 E2.1 Error Code

What the E2.1 code means

On Trane S-series furnaces with a seven-segment display (S9X1, S9X2, S9B1 and S8X1, S8X2), code E2.1 is retry lockout — flame was never sensed after 3 ignition tries in one call for heat, followed by a one-hour lockout.

Likely causes

  1. Failed or cracked hot surface igniter → Shop the hot surface igniter at RepairClinic
  2. Gas supply off or gas valve not opening
  3. Dirty flame sensor

How to fix it — step by step

  1. Wait out the one-hour lockout or reset power once
  2. Confirm the gas shutoff to the furnace is open and other gas appliances work
  3. Replace a dirty air filter
  4. If it locks out again, call a technician to test the igniter, gas valve and flame sensor → Shop the flame sensor at RepairClinic → Shop the gas valve at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the E2.1 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 error codes

See all Trane S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 codes & guides →