Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 E3.1 Error Code
What the E3.1 code means
On Trane S-series furnaces with a seven-segment display (S9X1, S9X2, S9B1 and S8X1, S8X2), code E3.1 means the first-stage pressure switch is shorted (closed when it should be open, before the inducer runs).
Likely causes
- Pressure switch stuck closed
- Water or debris in the pressure switch or hose
- Shorted pressure switch wiring
How to fix it — step by step
- Check outdoor vent terminations for blockages
- Check the condensate drain for clogs
- Reset power once and note if the code returns before the inducer starts
- Call a technician to test or replace the pressure switch → Shop the pressure switch at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the pressure switch.
Parts that commonly fix the E3.1 code
- pressure switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 error codes
See all Trane S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 codes & guides →