Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 E08 Error Code

What the E08 code means

On Trane S-series furnaces with a seven-segment display (S9X1, S9X2, S9B1 and S8X1, S8X2), code E08 means flame current is low but still strong enough to allow operation — the furnace may run, but the weak flame signal will eventually cause shutdowns.

Likely causes

  1. Dirty or oxidized flame sensor
  2. Poor burner ground
  3. Weak flame from dirty burners

How to fix it — step by step

  1. Replace the air filter and confirm registers are open
  2. Note whether the furnace short-cycles or drops out mid-cycle
  3. Book a technician visit soon — the furnace is warning before it fails
  4. A technician will clean or replace the flame sensor and verify flame current → Shop the flame sensor at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the E08 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 error codes

See all Trane S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 codes & guides →