Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 E11 Error Code
What the E11 code means
On Trane S-series furnaces with a seven-segment display (S9X1, S9X2, S9B1 and S8X1, S8X2), code E11 is a gas valve fault group — most commonly the first-stage gas valve was not energized when it should be, or a gas valve relay is stuck closed.
Likely causes
- Failed gas valve
- Control board gas valve relay fault
- Loose or damaged gas valve wiring
How to fix it — step by step
- Turn furnace power off and note the code
- Do not attempt to test or rewire the gas valve → Shop the gas valve at RepairClinic
- If you smell gas, leave and call the gas utility
- Call a technician to diagnose the gas valve and control board → Shop the control board at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the gas valve.
Shop the gas valve at RepairClinic or Amazon
Also tied to this fault: control board - Shop at RepairClinic or Amazon
Parts that commonly fix the E11 code
- gas valve - Shop at RepairClinic or Amazon
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 error codes
See all Trane S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 codes & guides →