Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 E01 Error Code
What the E01 code means
On Trane S-series furnaces with a seven-segment display (S9X1, S9X2, S9B1 and S8X1, S8X2), code E01 means an internal integrated furnace control (IFC) error — loss of the IRQ or other internal control failures.
Likely causes
- Failed control board
- Power surge or voltage transient
How to fix it — step by step
- Turn furnace power off for 30 seconds and back on once
- If E01 returns immediately, do not keep cycling power
- Note the code for the technician
- Call a technician to confirm and replace the control board → Shop the control board at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the control board.
Parts that commonly fix the E01 code
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 error codes
See all Trane S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 codes & guides →