Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 E05 Error Code

What the E05 code means

On Trane S-series furnaces with a seven-segment display (S9X1, S9X2, S9B1 and S8X1, S8X2), code E05 means flame was detected when it should not be present — a flame signal exists while the gas valve should be closed.

Likely causes

  1. Gas valve leaking or stuck open
  2. Shorted flame sensor wiring → Shop the flame sensor at RepairClinic
  3. Failed control board → Shop the control board at RepairClinic

How to fix it — step by step

  1. Turn furnace power off and close the gas shutoff to the furnace
  2. Do not keep resetting the furnace
  3. If you smell gas, leave the house and call the gas utility
  4. Call a technician to test the gas valve and flame-sense circuit → Shop the gas valve at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the E05 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 error codes

See all Trane S-series seven-segment display — S9X1/S9X2/S9B1/S8X1/S8X2 codes & guides →