Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) 4 + 7 Error Code

What the 4 + 7 code means

On Lennox G61MPV furnaces with the SureLight control, flash code 4 + 7 means an ignitor circuit fault — a failed ignitor or its triggering circuitry on the control.

Likely causes

  1. Cracked or burned-out hot surface igniter → Shop the hot surface igniter at RepairClinic
  2. Failed igniter circuit on the control board → Shop the control board at RepairClinic
  3. Loose igniter wiring

How to fix it — step by step

  1. Confirm the thermostat is calling for heat
  2. Reset power once and listen for the ignition sequence
  3. If the igniter never glows and the code returns, stop resetting
  4. Call a technician to test igniter resistance and replace the igniter or board

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the 4 + 7 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) error codes

See all Lennox G61MPV — SureLight single-LED paired-flash (X + Y) codes & guides →