Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) 2 + 3 Error Code
What the 2 + 3 code means
On Lennox G61MPV furnaces with the SureLight control, flash code 2 + 3 means the low pressure switch failed open — it did not close to prove inducer draft.
Likely causes
- Blocked intake or exhaust vent
- Clogged or frozen condensate drain
- Weak inducer motor → Shop the inducer motor at RepairClinic
- Failed pressure switch or cracked hose
How to fix it — step by step
- Clear snow, ice, leaves or debris from the outdoor intake and exhaust terminations
- Check the condensate drain and trap for clogs or freezing
- Reset power once (off 30 seconds, then on)
- If the code returns, call a technician to test the inducer and pressure switch — do not bypass the switch → Shop the pressure switch at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the pressure switch.
Shop the pressure switch at RepairClinic or Amazon
Also tied to this fault: inducer motor - Shop at RepairClinic or Amazon
Parts that commonly fix the 2 + 3 code
- pressure switch - Shop at RepairClinic or Amazon
- inducer motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) error codes
See all Lennox G61MPV — SureLight single-LED paired-flash (X + Y) codes & guides →