Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) 2 + 4 Error Code
What the 2 + 4 code means
On Lennox G61MPV furnaces with the SureLight control, flash code 2 + 4 means the low pressure switch failed closed — it was already closed before the inducer started.
Likely causes
- Pressure switch stuck closed
- Moisture in the pressure switch or hose
- Shorted switch wiring
How to fix it — step by step
- Check vent terminations and the condensate drain for blockages
- Reset power once and note whether the code appears before the inducer runs
- Call a technician to test or replace the pressure switch → Shop the pressure switch at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the pressure switch.
Parts that commonly fix the 2 + 4 code
- pressure switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) error codes
See all Lennox G61MPV — SureLight single-LED paired-flash (X + Y) codes & guides →