Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) 1 + 3 Error Code
What the 1 + 3 code means
On Lennox G61MPV furnaces with the SureLight control, flash code 1 + 3 means flame sensed out of sequence — a flame signal is still present when it should not be.
Likely causes
- Gas valve leaking or stuck open
- Shorted flame sensor wiring → Shop the flame sensor at RepairClinic
- Failed control board → Shop the control board at RepairClinic
How to fix it — step by step
- Turn furnace power off and close the gas shutoff to the furnace
- Do not keep resetting the furnace
- If you smell gas, leave the house and call the gas utility
- Call a technician to test the gas valve and flame-sense circuit → Shop the gas valve at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the gas valve.
Shop the gas valve at RepairClinic or Amazon
Also tied to this fault: flame sensor - Shop at RepairClinic or Amazon; control board - Shop at RepairClinic or Amazon
Parts that commonly fix the 1 + 3 code
- gas valve - Shop at RepairClinic or Amazon
- flame sensor - Shop at RepairClinic or Amazon
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) error codes
See all Lennox G61MPV — SureLight single-LED paired-flash (X + Y) codes & guides →