Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) 1 + 2 Error Code
What the 1 + 2 code means
On Lennox G61MPV furnaces with the SureLight control, flash code 1 + 2 means low flame current in run mode — the flame signal is weak while the furnace is running.
Likely causes
- Dirty or oxidized flame sensor
- Poor burner ground
- Weak flame from dirty burners
How to fix it — step by step
- Replace the air filter and open all registers
- Note whether the furnace short-cycles or drops flame mid-cycle
- Reset power once and observe a full heat cycle
- Call a technician to clean or replace the flame sensor and measure flame current → Shop the flame sensor at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the flame sensor.
Parts that commonly fix the 1 + 2 code
- flame sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) error codes
See all Lennox G61MPV — SureLight single-LED paired-flash (X + Y) codes & guides →