Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) 5 + 3 Error Code
What the 5 + 3 code means
On Lennox G61MPV furnaces with the SureLight control, flash code 5 + 3 means no earth ground — the control does not detect a ground. The G61MPV manual notes the control will restart if the error recovers.
Likely causes
- Disconnected or broken ground wire
- Poor ground at the electrical panel
How to fix it — step by step
- Confirm the breaker and furnace switch are on
- Do not operate the furnace long-term without a proper ground
- Call an electrician or HVAC technician to restore grounding
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the 5 + 3 code
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) error codes
See all Lennox G61MPV — SureLight single-LED paired-flash (X + Y) codes & guides →