Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) 5 + 6 Error Code
What the 5 + 6 code means
On Lennox G61MPV furnaces with the SureLight control, flash code 5 + 6 means low secondary (24VAC) voltage — the low-voltage supply from the transformer is too low.
Likely causes
- Failing 24V transformer
- Short or overload in the low-voltage circuit
- Loose low-voltage wiring
How to fix it — step by step
- Check the thermostat display — a blank thermostat can accompany low 24V power
- Confirm the blower door is fully seated
- Reset power once
- Call a technician to test the transformer and low-voltage circuit → Shop the transformer at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the transformer.
Shop the transformer at RepairClinic or Amazon
Also tied to this fault: control board - Shop at RepairClinic or Amazon
Parts that commonly fix the 5 + 6 code
- transformer - Shop at RepairClinic or Amazon
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) error codes
See all Lennox G61MPV — SureLight single-LED paired-flash (X + Y) codes & guides →