Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) 5 + 1 Error Code
What the 5 + 1 code means
On Lennox G61MPV furnaces with the SureLight control, flash code 5 + 1 is a hard lockout — the rollout circuit is open or was previously opened. This is a safety lockout that will not auto-retry.
Likely causes
- Flame rollout from a blocked or cracked heat exchanger
- Blocked venting
- Tripped manual-reset rollout switch
How to fix it — step by step
- Turn the furnace off and leave it off
- Do not reset the rollout switch yourself — the cause must be found first → Shop the rollout switch at RepairClinic
- Call a technician to inspect the heat exchanger and venting before the furnace runs again
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the rollout switch.
Parts that commonly fix the 5 + 1 code
- rollout switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) error codes
See all Lennox G61MPV — SureLight single-LED paired-flash (X + Y) codes & guides →